42
OPERATION
Using the hob equipped with igniter knobs
("Zp" model)
● push down the knob of a selected burner
until you feel resistance and turn left to the
"large ame"position
● hold the knob until gas ignites
● once ame ignites, release the knob and
adjust ame size.
Using the hob equipped with a flame-
failure cut-o device ("Zt" model)
In hobs equipped with a ame-failure
cut-o device, hold the pushed down
knob in the "large ame" position for
approximately 10 seconds to activate
the a ame-failure device
.
Repeat the above step if ame does
not ignite.
If ame is extinguished, the ame-
failure device will cut o gas supply
within about 60 seconds.
You can open and control the gas
supply to the burners using knobs
with ame-failure cut-o device (Zt
models).
To Next Page
Loading...
