Fagor 3MFT-2AC - Page 37

37
OPERATION
Control Panel
When you connect the hob to mains, you will hear a short beep and sensors will be locked.
Touch and hold
for 3 second to release the lock.
Important!
Do not place any objects on the sensors as this could cause an error. Always
keeptouchsensorsclean.
Turnonthehobandacookingzone
If none of the sensors is touched within 10 seconds, the appliance switches itself o.
If child lock function is activated, the appliance cannot be switched on (see "Release
the child lock").
Touch to turn on the hob and a selected
cooking zone. Active cooking zone display
will show “0.” Now set the desired heat
setting using the
and touch sensors
(see Set the heating power)
Important!
Thehobisonwhenyouactivateacookingzone.
Set the heat setting
When the power is set to "0" you can adjust it
using the
or sensor.
When both cooking zones operate and you
need to adjust heat setting of the rst cooking
zone. Briey touch
and then touch or
to adjust the heat setting.