Fagor 3MFT-2AC - Page 42

42
OPERATION
Limit the operating time
In order to increase eciency, the cooking
surface is tted with a operating time limiter
for each of the cooking zones. The maximum
operating time is set according to the last heat
setting selected.
If you do not change the heat setting for a long
time (see table) then the associated cooking
zone is automatically switched o and the
residual heat indicator is activated. However,
you can switch on and operate individual
cooking zones at any time in accordance with
the operating instructions.
Timer
If the appliance is equipped with a timer, it can be used to set the operating time of any cook-
ing zone.
To use timer with a cooking zone, it must operate with a heat setting of at least 1. If this condi-
tion is met:
- touch the timer sensor,
- touch or to set the time from 0 to 99
When you touch or the letter “t” will be shown on the relevant cooking zone display.
When both cooking zones operate:
- briey touch
by the cooking zone for which you wish to set the timer. Continue as de-
scribed above.
When timer is counting down the letter “t” will alternate with the heat setting on the display.
When timer counts down to zero the cooking zone will turn o automatically and you will hear
a beep.
Touch
and simultaneously to cancel the timer.
Cookingheat
setting
Maximum op-
erating time
(hours)
1 10
2 5
3 5
4 4
5 3
6 2
7 2
8 2
9 1