EN 8
Fig. 7
CONNECTING THE HOB TO AN LPG CYLINDER
Do not install the appliance in the basement or in any other room whose floor is below
the ground level as LPG is heavier than air and accumulates at the floor level.
The cylinder should be located in an easily accessible place, positioned vertically and
secured against falling over.
When connecting the appliance to the cylinder use a flexible tube.
To connect the appliance use the LPG tip with a gasket as shown in fig. 8.
Each time after connecting the hob to LPG cylinder check the soundness on high
pressure side, check the cylinder valve for soundness and the connection of regulator
with the cylinder and its operation.
The soundness of all connections and the cylinder valve maybe pre-checked by applying
soap solution on the said points with the normal working pres-sure. Appearing bubbles
signal the escape of gas.
Fig.8
To Next Page
Loading...
Need help?
General
