Fagor 8065 - Page 25

Error solving manual.
CNC 8060
CNC 8065
·25·
(REF: 1709)
1081 'Incompatible G functions (G264/G265)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1082 'Incompatible G functions (G200/G201/G202)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1083 'Incompatible G functions (G36/G37/G38/G39)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1084 'Plane change not allowed while tool radius compensation is active'
DETECTION During execution.
CAUSE The CNC has tried to change the work plane or the axes that make up the plane, while
tool radius was active.
SOLUTION Cancel the compensation to define the new work plane.
1085 'G41/G42 not allowed if the first or second axis of the active plane is missing'
DETECTION During execution.
CAUSE Tool radius compensation is impossible if one of the two axes of the active plane is
missing in the channel.
SOLUTION Define the work plane. If the channel has yielded its axes to other channels, recover
the missing axis using the instruction #CALLAX or #SET AX.
1087 '"=" expected'
DETECTION During execution.
CAUSE Wrong syntax of the programmed instruction or function.
SOLUTION Check the program.
1088 'Wrong offset number'
DETECTION During execution.
CAUSE In function G159, the programmed zero offset does not exist.
SOLUTION Check the program.
1089 'Incompatible M functions (M3/M4/M5/M19)'
DETECTION During execution.
CAUSE Two or more M functions incompatible with each other have been programmed for
the same spindle in the block.
SOLUTION Program the M functions of the same spindle in different blocks.
1090 'Nonexistent H function'
DETECTION During execution.
CAUSE The H function does not exist.
SOLUTION The function number must be between 1 and 65534.
1091 'T function programmed twice'
DETECTION During execution.
CAUSE More than one T function have been programmed in the same block.
SOLUTION Each block can only contain one T function. Program both functions in different
blocks.
1093 'D function programmed twice'
DETECTION During execution.
CAUSE More than one D function have been programmed in the same block.
SOLUTION Each block can only contain one D function. Program both functions in different
blocks.