Fagor BCSD - Connection: CNC to SCD Spindle Drive

·30·
Installation manual
BCSD
System
3.
CABLES
REF. 1711
Connection between CNC and SCD spindle drive
3.1 Connection between CNC and SCD spindle drive
Cable name: BSC-CS-XX-01
Cable between CNC Communications board CAN AXES connector and spindle drive SCD X6
connector.
Length: 5 m - 10 m - 15 m.
Pinout.
2 x 5-pin male Phoenix minicombicon connector (3.5 mm pitch).
Characteristics of the CAN cable:
Type: Shielded.
Twisted pairs (1 x 2 x 0.22 mm2).
Flexibility: Superflexible.
Minimum static bending radius of 50 mm and a dynamic radius of 95 mm.
Cover: PUR.
Impedance: Cat.5 (100 W - 120 W).
Signal Description
ISO GND Ground / 0 V.
CAN L Bus signal (LOW).
SHIELD CAN shield.
CAN H Bus signal (HIGH).
SHIELD CAN shield.
ISO GND
CAN L
SHIELD
CAN H
SHIELD
1
2
3
4
5
1
2
3
4
5
Pin Pin
ISO GND
CAN L
SHIELD
CAN H
SHIELD