22/07/2019
44
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
9.6.2. START -UP
o When the electrical power to the machine is switched on, the software version is displayed for 5 seconds.
o On pressing ON/OFF (while the machine is powered), the appliance is switched ON. All the relays are
disconnected except RG.
o On pressing ON/OFF (while the machine is powered), the machine is switched off, OFF. All the outputs are
set to 0.
o Whenever the machine loses the mains power supply, the appliance switches to OFF when the power
supply is recovered.
o If the door is opened (IP=0 contact) while the machine is operating (in cycle), the time counter stops and
outputs, CMBL1, CBML2, BA are set to “0”. When the door is closed again (IP=1 contact), all the outputs
are restored and the time counter resumes counting.
o Press START/STOP to run START or stop STOP a programme. If a programme is stopped by pressing
START/STOP, when it is restarted by pressing START/STOP again, the programme returns to the start of
the programme. i.e. the programme does not make a pause.
o While the tank is filling, the tub is filled to the correct level. This level varies with the model.
9.6.3. ADJUSTMENT OF PARAMETERS
The configuration and parameters may ONLY be adjusted by QUALIFIED AND AUTHORISED
PERSONNEL.
The “ADVANCE” model has a system configuration menu for the use of the technical support service.
To Next Page
Loading...
Need help?
General
