13
the selection has been made the value
will stop ashing on the display.
• If the display is in the temperature
display mode (9) or in the automatic
shut off timer mode (10), rst use the
Menu button (7) to switch the display
to the power level display mode (8) and
then set the desired power level.
• If during cooking you again use the
Menu button to switch to the power
level display mode, the value “P-6” will
appear on the display.
SETTING THE TEMPERATURE (9)
• Using the Menu button (7) switch the
display to the temperature display
mode (9). The cooking temperature is
automatically set to 140°C. Use the
control dial (4) to select the desired
cooking temperature in the range
60–220 °C. During this selection the
value ashes on the display. After the
selection has been made the value will
stop ashing on the display.
• If during cooking you again use the
Menu button (7) to switch to the
temperature display mode, the value
140 °C will appear on the display.
SETTING THE AUTOMATIC SHUT-OFF
TIMER (10)
• Using the Menu button (7) switch the
display to the timer display mode
(10). Using the control dial (4) set the
automatic shut off time in the range
0–180 minutes. Slowly turn the control
dial (4) to increase or decrease the
automatic shut off time by 1 minute.
Quickly turn the control dial to increase
or decrease the automatic shut off time
by 10 minute intervals.
• As soon as you set the timer, the value
on the display will stop ashing and
will start to countdown the time to the
automatic shut off. Until the automatic
shut off of the induction hotplate, the
remaining time until automatic shut off
and the set power level or temperature
will alternate on the display.
• At the end of the set automatic shut off
time a sound is made and the induction
hotplate turn itself off. The value "0"
ashes on the display and the induction
hotplate is in the stand-by mode.
• If you do not set the automatic shut off
time, the value "---" will stop ashing
and the display will switch to the mode
showing power and temperature.
TURNING OFF THE INDUCTION
HOTPLATE
Turn off the induction hotplate by pressing
the
button (6). The value "0" will ash on
the display and the induction hotplate will
be in stand-by mode.
Note: After being turned off the fan will
start for a short time to speed up the
cooling of the induction hotplate. Do not
disconnect the induction hotplate until the
fan stops working.
6. CLEANING AND MAINTENANCE
1. Unplug the appliance and allow the hob
to cool down.
2. Use a soft dry cloth to gently remove
any dust that has accumulated in the air
vent and air inlet.
3. If the hob is not excessively dirty, clean
it with a damp cloth.
4. If there are grease stains on the hob,
clean it with a damp cloth and a little
toothpaste or neutral detergent.
5. Never use abrasive or degreasing
cleaning agents or alcohol.
To Next Page
Loading...
