For users
2. Operations
2.1. Notice before using
The user ① is advised to start the water pump before the heat pump, and turn off the
heat pump before the water pump for long life circle.
② Check firstly for any water leakage of piping connection, then power on, press the
ON/OFF button of the heat pump, and set suitable temperature.
2.2. Operation instructions
Symbol Designation Operation
Power ON/OFF Press to power on or off the heat pump
Mode Press to select Smart/Silence mode
Up/ Down Press to set desired water temperature
Note:
You may set the desire① d water temperature from 18 to 35 . ℃
The ② on the right shows the inlet water temperature. The on the left shows the
set temperature by pressing or button.
After you turn on the ③ heat pump, the fan will start to run in 3 minutes. In another 30
seconds, the compressor will start to run.
④
During heating, the will be light.
5
To Next Page
Loading...
