65
EN
Pollen lter and electro-static lter can be washed, but make sure they are completely dry
before installing back. For washing electro-static lter just place it under tab water and never
rub with another object or touch any of its wires.
NOTE!
If wires and contacts are damaged ESF will not operate.
When installing pollen lter on ESF, pollen lter should be located as shown in the picture
below aligned with its short tabs to red panel of electro-static lter housing.
ATTENTION!
If pollen lter is not installed properly on ESF, lters will not seat into their housing on the
appliance.
Magnets on electro-static lter should be facing upwards and lter contacts should align the
contacts at the lter housing of the appliance.
When the lters are located into their housing, pollen lter should be at the rear and black
panel of the electro-static should be facing backwards.
To Next Page
Loading...
