How to fix a misaligned oven door on Falcon toledo Cookers?
To fix a misaligned oven door on Falcon Cookers, adjust the bottom hinge of the door. Loosen the bottom hinge fixing screws and use the notch and a flat bladed screwdriver to adjust the hinge position. Afterward, retighten the hinge screws.
What to do if the oven light is not working in my Falcon toledo?
If the oven light in your Falcon Cookers isn't working, the bulb has probably burnt out. You can purchase a replacement 15 W – 230 V lamp specifically designed for ovens (heat resistant to 300 °C) from an electrical shop. Ensure you turn off the power at the circuit breaker and allow the oven to cool before replacing the bulb. Remove the oven shelves, unscrew the bulb cover counter-clockwise (it may be stiff), and carefully unscrew the old bulb (using a glove in case it shatters). Screw in the new bulb, replace the cover, and turn the circuit breaker back on.
What to do if the grill is not cooking properly on my Falcon toledo?
If the grill on your Falcon Cookers isn't cooking properly, ensure you're using the pan and trivet supplied with the cooker. Make sure the pan is on the runners, not the compartment floor, and that the grill tray is pushed fully back to stop.
Why is the oven temperature getting hotter on my Falcon toledo as it gets older?
If the oven temperature on your Falcon Cookers is getting hotter as it gets older, and turning the temperature down using the oven control knob hasn't worked (or only worked briefly), you might need a new thermostat. A service person should fit this.
Details on installing and maintaining the appliance for optimal performance and longevity.
Crucial safety instructions including gas leaks, ventilation, personal safety, and addressing unusual smells.
Overview of gas and fan ovens, including their functions and operating instructions.
Overview of the grill and oven functions, including their operation and safety.
Addresses common problems like hot knobs, noisy fans, steam, and uneven cooking.
Diagnostic steps for oven not coming on, timer issues, temperature drift, and burnt-out light.
Details for installers, safety requirements, ventilation, and location.
Fitting stability brackets and chains, and final levelling adjustments.
Procedures for connecting the cooker to gas and electricity supplies.
Verifying electrical safety through earth continuity and polarity checks.
Instructions for converting from natural gas to LPG Propane, including safety.
Critical safety warnings before and during servicing operations.
To Next Page
General
