Lumina 71 Alarm
49
'WEIGHER IS NOT EMPTY' L After dosing out there is still feed in the weigher/blender.
'WEIGHER NOT STABLE' L No stable weight can be determined.
'NO DECREASE' L During dosing out the weigher does not empty.
'Max. dos.out time' L Maximum time to complete dosing out.
' HOPPER NOT EMPTY
“Number”
L Required hopper is not empty.
“SENSOR HOPPER ”Number” L The empty report sensor is not covered during dosing out the
weigher, or is not uncovered when the hopper is dosed out.
External alarm!!! S/L External alarm input not closed. (entered text will appear).
"Assign IO" L The IO address is not suitable for this hardware (e.g. address
0.13 for IOB.4).
Circuit alarms
'NO PULSES circuit Number” L No circuit pulses are reported back.
'Overflow “FP number” S The control computer has detected feed in the overflow
hopper for the listed valve number.
'Overflow CIRC “Number” L The control computer has detected feed in the overflow
hopper.
'CIRCUIT “Number” BLOCK' S Circuit is blocked.
Route alarms
Section error
'SECTION MOTOR
“Number”
L The control computer has sent a drive command to the
section (auger), but there is no feedback signal to indicate
that it is actually running.
'ROUTE “Number” BLOCK' S Route is blocked.
To Previous Page
Loading...
