Need help?Do you have a question about the Fantec DB-AluSky U2e and is the answer not in the manual?
General| Material | Aluminum |
|---|---|
| Interface | USB 2.0 |
| Type | External |
| Supported Drives | SATA |
| Operating System Compatibility | Windows, macOS, Linux |
Open the hard drive enclosure to reveal its internal structure.
Connect the HDD to the electronic board, ensuring the SATA connector is properly seated.
Screw the HDD onto the tray or use the provided fixing pad for stability.
Close the enclosure and secure the rear cover with screws.
Right-click "My Computer" and select "Manage" to open system tools.
Locate the external HDD in Disk Management, which should appear as "Unallocated".
Right-click the unallocated space and select "New Partition".
Proceed through the wizard steps to configure and create the partition.
After partitioning, the HDD will be recognized as a "New Volume".
Open "My Computer" to see the newly created volume on your PC.
Download and install the backup utility software from the provided driver CD.
Guide to using the software to create backup plans, select files, and set backup destinations.
Initiate the data restoration process by clicking the "Restore" button in the software.
Choose the desired backup profile and version to restore from the available list.
Specify which files to restore and choose the destination folder on your computer.
Input the password if the backup was encrypted to decrypt the files.
Allow the restoration process to finish, monitoring the progress.
To Next Page
