MAINTENANCE TABLE
82
Position Operation
1.000 km
(600 mi)
10.000 km
(6.000 mi)
20.000 km
(12.000 mi)
30.000 km
(18.000 mi)
Yearly
check
Tires
– Check tread depth and damage;
– Replace if necessary;
– Check air pressure;
– Correct if necessary.
√ √ √ √
Wheel bearings
– Check that the bearings are not loose or
damaged.
√ √ √
Swingarm
– Check its operation and excessive
clearance.
√ √ √
– Lubricate with lithium soap grease.
Every 30000 km (18.000 mi)
Drive Chain
– Check the tension, alignment and
condition of the drive chain;
– Check and verify the sprocket and
pinion;
– Check the clearance on the rear
chainring sprocket;
– Adjust and fully lubricate the drive chain
with a specific lubricant.
Every 1000 km (600 mi)
Following heavy use
– Replace.
If the chain exceeds an elongation of 2%,
replacement of the chainring and sprocket is also
recommended
Handlebar bearings
– Check the bearing clearance and the
handlebar hardness.
√ √ √ √
– Lubricate with lithium soap grease.
Every 20000 km (12.000 mi).
Motorcycle Frame
Fixings
– Make sure that all nuts, bolts and
screws are properly tightened.
√ √ √ √
Brake lever rotation
pin
– Lubricate with silicone grease..
√ √ √ √
To Next Page
Loading...
