USE AND MAINTENANCE MANUAL - SECTION 4
ELEVAH 40 MOVE / 40 B AERIAL PLATFORM – Rev. 12_2021
SECTION 4. CONTROLS, WARNING LIGHTS AND MACHINE OPERATION
INTRODUCTION
CAUTION
THE MANUFACTURER DOES NOT HAVE ANY DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND OPERATOR ARE REQUIRED TO COMPLY
WITH THE CORRECT SAFETY PROCEDURES.
The ELEVAH 40 MOVE / 40 B model lifting devices are electric machines equipped with a cage
assembled onto a lifting mechanism with uprights.
The lifting device is INTENDED TO MOVE PEOPLE TO THEIR WORK POSITIONS WHERE THEY
CAN CARRY OUT THEIR TASKS FROM THE CAGE.
The main control station is located in the cage. The operator can drive the machine (on self-propelled
machines) and lift and lower the cage from the control console.
Vibrations generated by machines do not constitute any danger for the operator who is inside the
cage.
The continuous sound pressure level (A-weighted) in the cage is less than 70 db (A).
MACHINE OPERATION
Preliminary operations
It is necessary for the following control conditions to be satisfied, before activating the machine from
the cage controls.
• The voltage of the batteries, if any, must be sufficient to activate the machine;
• The emergency stop switch with removable key, located on the control station in the cage
must be on RESET.
CHARGING THE BATTERY
The machine is fitted with a battery charger with AC voltage input/DC voltage output. The battery
charger automatically stops charging when the batteries are fully charged.
CAUTION
KEEP SPARKS, NAKED FLAMES OR CIGARETTES AWAY FROM THE BATTERIES.
PROVIDE ADEQUATE VENTILATION WHILE CHARGING.
NOTE: when the battery charger is connected to an AC socket, the transmission function of the
machine is disabled.
To Next Page
Loading...