12
1
2
3
1
2
3
To open the dispenser, turn the cap to the “open” (left) arrow and lift it out.
Pour the rinse aid into the dispenser, being careful not to overfill.
Replace the cap by inserting it aligned with “open” arrow and turning it to the closed
(right) arrow.
Note:
Note:
Clean up any rinse aid split during filling with an absorbent cloth to avoid excessive foaming
during the next wash. Don’t forget to replace the cap before you close dishwasher door.
The rinse aid dispenser has four settings. The
recommended setting is on “3”. If the dishes still are not
drying properly or are spotted, adjust the dial to the next
higher number on “4”.
Increase the dose if there are drops of water or lime spots on
the dishes after washing. Reduce it if there are sticky whitish
stains on your dishes or a bluish film on glassware or knife
blades.
M
A
X
Adjusting Rinse Aid Dispenser
Adjust lever
(Rinse)
To Next Page
Loading...
