22
Turning On The Appliance
Change The Program
Forget To Add A Dish?
Starting a wash cycle:
1. Draw out the basket(see the section entitled “Loading the Dishwasher “ );
2. Pour in the detergent (see the section entitled “Detergent and Rinse Aid “ );
3. Insert the plug into the socket. The power supply is 120V/60 Hz;
4. Make sure that the water supply is turned on to full pressure;
5. Close the door and press the Power button to turn on the power supply;
6. Press the program button to select wash program you need
Heavy->Normal->ECO->Baby Care->Glass->Speed->Rinse
7. Then press the Start/Cancel button, the dishwasher begins to start.
Premise: You can modify the washing program, When the dishwasher just
runs for a short time. Otherwise, the detergent may have already been
released, and the appliance may have already drained the wash water. If this
is the case, the detergent dispenser must be refilled (see the section entitled
“Loading the Detergent“).
To change the washing program, press Start/Cancel button more than three seconds the
machine will be in stand by state, then you can change the program to the desired cycle
setting (see the section entitled “Starting a wash cycle“).
The lights show the state of the dishwasher:
a. All phase lights off---------------------------On standby
b. The display no blinking---------------------Being paused
c. The display blinking-------------------------Running
Note:
If you open the door when washing, the machine will pause. When you close the
door, you need to press Start/Cancel button to keep the machine working.
2
After the spray arms stop working, you can open the door
completely.
Add forgotten dishes.
5
1
Open the door a little to stop the washing.
4
Close the door
Press the Start/Cancel button, the dishwasher will ru
after 10 seconds.
To Next Page
Loading...
