34
Problem Possible Causes What To Do
See notes in " Loading t
The dishes were not
loaded correctly.
he Dishwasher Baskets ".
The dishes
are not clean
The dishes
are not drying
Cloudiness
on glassware
Black or gray
marks on dishes
Detergent left in
dispenser cups
Select a more intensive program.
See" Wash Cycle Table ".
Use more detergent, or change your detergent.
Rearrange the items so that the spray can rotate freely.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See "Cleaning the Spray
Arms".
Use a mild abrasive cleaner to eliminate those marks.
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/Refill the rinse-aid
dispenser.
In short programs the washing temperature is lower.
This also lowers cleaning performance. Choose a
program with a long washing time.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once t
he dishes are barely warm to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
The program was
not powerful enough.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
Not enough detergent
was dispensed.
Item are blocking
the path of spray arms.
Combination of soft
water and too much
detergent.
The filter combination
in the base of wash
cabinet is not clean or
is not correctly fitted.
This may cause
the spray arm jets
to get blocked.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed
too soon.
Wrong program
selection
Using cutlery with
a low-quality coating
Unsatisfactory
Unsatisfactory
washing
result
drying
result
To Next Page
Loading...
