Fasep V585.2.U - How to Apply the Weight Using ALU-SE Applicator; How to Apply the Weight Using LASER; How to Use SPLIT Program

Fasep 2000 srl Rev. 1.6
Videotronic V585.2.U: User’s Manual 14 march 2022
3-9
Fig. 60
Fig. 63
Fig. 64
7.5 How to apply the weight using ALU-SE applicator
Place the weight as in the picture 61.
Turn the wheel until reach the application
position of the weight (fig. 60).
Move the rod until reach the application
position of the weight.
Apply the weight(fig. 62).
Repeat the procedure for the other side.
.
7.6 How to apply the weight using LASER
Turn the wheel until the position weight
indicators of one side are both green (fig. 63).
The laser come out to show the point of
application of the weight (fig. 64).
Apply the weight on the laser dot.
Repeat the procedure for the other side.
7.7 How to use SPLIT Program
After the measurement spin
Press <SPLIT> to select the program.
Turn the wheel until first spoke (green position) is at 12 0' clock.
Press <SET/OK> to confirm.
Turn the wheel until second spoke (red position) is at 12 o’ clock
Press <SET/OK> to confirm the red position.
Balance the wheel applying weight on green and red positions.
Fig. 61
Fig. 62