Fasep 2000 srl Rev. 1.6
Videotronic V585.2.U: User’s Manual 14 march 2022
iii
ORIGINAL INSTRUCTIONS
TABLE OF CONTENTS
WARNING .......................................................................................... ii
SYMBOLS AND CONVENTIONS ........................................................................ ii
1 PRESENTATION ............................................................................1-1
1.0 Intended Use .......................................................................1-1
1.1 Definitions .........................................................................1-1
2 INSTALLATION .............................................................................2-1
2.1 Moving the unit......................................................................2-1
2.2 Assembling the unit ..................................................................2-1
2.3 Installation .........................................................................2-1
2.4 Electrical Hookup....................................................................2-1
2.5 Compressed air Hookup (PL models only) ................................................2-1
3 USE OF CONTROL PANEL....................................................................2-2
3.1 Meaning of the icons on the screen ......................................................2-2
4 CALIBRATION OF WHEEL BALANCER ..........................................................2-5
4.1 How to calibrate the wheel balancer (USER) ...............................................2-5
4.2 How to control the calibration of wheel balancer and position weight (USER) .....................2-6
5 Calibration ALU-SE ..........................................................................3-5
6 Calibration SONAR ..........................................................................3-6
7 MEASUREMENT AND CORRECTION OF UMBALANCE ............................................3-7
7.1 Placing the wheel rim on the wheel balancer ...............................................3-7
7.2 Input of Rim Dimensions (Sonar system version) ...........................................3-7
7.3 Input of Rim Dimensions (ALU-SE or LASER version) .......................................3-8
7.4 Detecting and correcting umbalance .....................................................3-8
7.5 How to apply the weight using ALU-SE applicator ...........................................3-9
7.6 How to apply the weight using LASER ....................................................3-9
7.7 How to use SPLIT Program ............................................................3-9
8 HOW TO OPTIMIZE UNBALANCE OF THE WHEEL ................................................4-1
9 SPECIAL FUNCTIONS .......................................................................5-1
9.1 Language selection ..................................................................5-1
9.2 Setup .............................................................................5-1
APPENDIX ........................................................................................ A-2
A: Technical data ..................................................................... A-2
B: Environmental Data, Safety Features and Requirements .................................... B-1
C: Errors and Malfunctions recognized by the Computer ....................................... B-2
To Next Page
Loading...
