www.fassride.com
(866) 769.3747
STEP 1:
INSTALL ELECTRICAL HARNESS
D. Secure relay and fuse in an upright position, as shown, to prevent moisture from
entering. Di-electric grease may be applied to prevent corrosion.
RELAY
FUS
E. Locate the fuse panel on the kick panel of the dash. Route the single red wire of the FASS harness
through the firewall and to the fuse panel.
F. Using a test light, locate a key-on fuse in the fuse panel. Once you have located a key-on fuse cavity, install
the existing fuse in the lower fuse location on the 46405 add-a-circuit. Install the 46405 into the selected
cavity.
Note: The supplied
3amp fuse in the
top fuse cavity!
The OEM fuse is to
go in the bottom
cavity!
To Next Page
