www.fastech.co.kr - 6
◆ Operation
◆ Check and Repair
If a protection function(alarm) occurs, firstly remove its cause and then release(alarm reset)
the protection function.
If you operate continuously without removing its cause, the machine may get damaged or
the user may get injured.
Do not make Motor Free and make input signal to ON during operation.
Motor will stop and stop current will become zero. The machine may get damaged or the
user may get injured.
Make all input signals to OFF before supply input voltage to S-SERVOⅡ.
The machine may get damaged or the user may get injured by motor operation.
All parameter values are set by default factory setting value. Change this value after
reading this manual throughly.
Otherwise, the machine may get damaged or other kinds of accidents may occur.
Stop to supply power to the main circuit and wait for a while before checking or
repairing the S-SERVOⅡ.
Electricity remaining in the capacitor may cause danger.
Do not change cabling while power is being supplied.
Otherwise, the user may get injured or the product may get damaged.
Do not reconstruct the S-SERVOⅡ.
Otherwise, an electric shock may occur or the reconstructed product can not get
After-Service.
Attention
Attention
To Next Page
Loading...
Need help?
General
