FEDCO MSD-200 - Page 20

MSD
TM
Series
© Copyright 2018 Fluid Equipment Development Company | www.fedco-usa.com
- 20 -
Pump Assembly Continued
LITTLE OR
NO MOVEMENT
LITTLE OR
NO MOVEMENT
LITTLE OR
NO MOVEMENT
LITTLE OR
NO MOVEMENT
9. Inspect the exible coupling radial and axial
t. It should have little or no movement and
be slightly more loose than the motor shaft
t. It should also slide smoothly on and o󰀨
the pump shaft.
10. Once proper exible coupling t on both
shafts has been obtained, remove the ex-
ible coupling and proceed with Initial Pump
Alignment.
NOTES: The exible coupling will not be need-
ed until the Final Pump Alignment procedure.
Figure 27 - Check Flex Coupling Fit
SMOOTH MOVEMENT