FEDCO MSD-200 - Final Pump Alignment

To Next Page

To Previous Page

MSD

Series

- 41 -

Pump Assembly Continued

“REMOVE BEFORE

OPERATION”

Figure 75 - Seperating Coupling Hubs

2. Separate the motor hub from the dropout

hub.

Figure 74 - Alignment Bushing Removal

Final Pump Alignment - No Motor Adapter

NOTES: Motor and pump to be installed on

baseplate and Initial Pump Alignment proce-

dure completed.

NOTES: The following steps outline the dial

indicator method. If using the Reverse Indica-

tor or a Laser Alignment Tool Method, retain

alignment bushing until indication has been

completed.

NOTES: Account for indicator sag. Angularity

determined by coupling manufacturer. Contact

FEDCO or see Sag Test section for additional

information.

1. If present, remove alignment bushing and

retain for future alignment purposes.

16. Install coupling guards and secure screws.

Figure 73 - Coupling Guard Installation

FEDCO MSD-200 - Final Pump Alignment - No Motor Adapter