Note: only support import one LOGO a time
3.4 Switch Source
When you access the five source buttons, the lights on the source buttons will appear in
three states:
green constant: the signal is currently on the main output;
green flashing: the currently selected, signal is being edited;
unlit: the source is not accessed or the resolution of the accessed source is not supported by
the L4
After transition effect and transition mode is selected
In AUTO+Time Mode:
1. Press a source button (1, 2, 3, 4 or 5) ,the selected button is green flashing.
2. Selected source will be switched to the output with the set TIME and using the
transition selected, the pressed source button becoming green constant .
Slide the T-BAR to switch
1. Press a source button (1, 2, 3, 4 or 5) the selected button is green flashing.
2. Slide T-Bar from top end to bottom end or reversely, then the pressed source button
becoming green constant.
To Next Page
Loading...
