Feelworld L4 - Chapter 5 Feelworld Live Plus Software Operation; 5.1 Connect L4 and computer

23
Note: The IP address of the L4 must be in the same WLAN segment as the computer or the mobile control
device you choose.
Chapter 5 Feelworld Live Plus Software Operation
Feelworld Live Plus is a software that allows you to control your L4, FEELWORLD is available
for all platforms including Android, iOS, MacOS, Windows.
Minimum System Requirements for macOS
Windows：
● CPU: i5 and above
● Memory:8 GB or more
● Operating System: Windows 10 64 bit processor or above
● Graphics: Support Direct X9 128M or above (open AERO effect)
● Hard disk space: Above 16G (primary partitions, NTFS format)
● Connector: USB 3.0 or type-c
● Others: do not run multiple video capture or editing software simultaneously
MAC：
●
CPU：i5 and above
● Connector: USB 3.0 or type c
● Operating System: macOS 11.0 Big Sur or later
macOS 10.15 Catalina
● Others: do not run multiple video capture or editing software simultaneously
You can either connect the L4 directly to your computer via the LAN port provided by the L4,
or link the L4 to your router and the computer to the Wi-Fi emitted by your wireless router.
5.1 Connect L4 and computer
5.1.1 Direct Link via a Network Cable
(1) Modify L4’s IP Address
The L4 is connected to a computer via TCP/IP protocol for data transfer. Therefore, you need
to keep the L4 on the same IP network segment as your PC or mobile device. If the L4 is
connected directly to a computer, you need to change the L4's IP manually to avoid IP
conflicts on the same network segment.
Steps to modify L4’s IP address:
①. click icon --IP address
②. click the value which need to modify and
rotate the knob to modify or swipe left and right
to modify.