21
Fig.33-3 The switch rocker arm is fully closed
●Note: When using this function, please turn off the machine.
●Note: When fully closed, check that the rear panel bezel
securely locks the rear cover.
●Note: When fully closed, please check if the switch rocker arm
has been closed by the rear cover
●Note: It is strictly forbidden to remove the auxiliary hose when
the machine is working.
2. Attach the auxiliary hose tail connector to the rear cover hose
connector. (See Fig 34-1, 2)
Fig.34-1 Open the cover
Fig.34-2 Fixed interface
3. Start the machine，Point the hose mouth at the trash。（ see fig 35）
Fig.35 Using a hose
6）-3. Auxiliary hose use precautions.
1. Please understand in detail the operation according to the "Precautions for the working area of the whole machine (pages 14-15)" and the
following precautions.
●Note: Please understand the parameters of the auxiliary hose in “Accessory Parameters (page 14)” before use.
●Note: When working, try to straighten the hose and work it to ensure maximum suction and wind speed.
●Note: It is strictly forbidden to point the hose to others or any non-working area during work.
●Note: It is strictly forbidden to load and unload the hose interface when the machine is started.。
●Note: Do not pull the hose to move the machine forward or backward.
●Note: Do not align the hose head with liquids, fire, and hazardous gases.
●Note: Do not pick up the trash that is larger than the hose port.
●Note: When the hose is clogged, stop the machine and then maintain it.
●Note: Keep the hose away from the engine silencer.
To Next Page
Loading...