Feig Electronic ID MAX50.10-E - Connection with External Powered Supply

To Next Page

To Previous Page

OBID

classic-pro Installation ID MAX50.10-E/-RE

FEIG ELECTRONIC GmbH Page 32 of 39 M90802-1de-ID-B-FCC.doc

E N G L I S H

8.1.4. Connection with External Powered Supply

Ethernet

ID CPR.IO

ID CPR50.10-E

Door Contact

NOTICE:

• Use only regulated power supply’s.

• Reversing the polarity of the supply voltage may destroy the device.

• Supply voltages outside the specifications may destroy the device.

• If switching power supplies are used with the module, be sure that there is adequate fil-

tering.

• Noise from the power supply can result in a reduction of the read/write range of the

module.

Other manuals for Feig Electronic ID MAX50.10-E