7
M a i n t e n a n c e
Strictly speaking, there is no maintenance required for your machine except occasionally
wiping it off with a soft cloth dampened with plain water. You can, however, help extend its
life if you always:
• Make sure the punching surfaces of documents and covers are clean and free of metal
• Empty the waste drawer
+
regularly to prevent debris from interfering with the dies, and
• Close the covers after each use to keep out dust and foreign objects.
Tro u b l e s h o o t i n g
If you experience a problem with your machine, you may be able to solve it quickly
yourself:
•
Red standby light
(
or stuck punching bar
.
Your machine is jammed, most likely
due to punching too many sheets at one time. Follow the jam-clearing procedure
described in O p e r a t i o n.
•
P a rtial last hole
Sheets are not properly aligned. With A4 documents, move document
wheel
%
to improve centering; with all other formats, make sure the edge guide
$
is in
the correct position and the corresponding die has been raised.
•
Punch holes not parallel to edge
Debris is stuck below the dies. Take a ruler or stiff
cardboard and slide it into the entry
"
, moving it back and forth to release cuttings into
the waste drawer
+
.
•
Dam aged hole edges
You may be trying to punch too many sheets at one time. Re d u c e
the number of sheets per batch.
If these measures do not solve your problem, please contact us through one of the many
channels listed under Customer Serv i c e.
SAFETY REMINDER :
Do not attempt to repair
your machine.
To Next Page
Loading...
Need help?
General
