How to fix Fellowes Laminator with no control panel illumination?
If there is no control panel illumination on your Fellowes Laminator, make sure the machine is switched on at the rear next to the plug inlet and at the wall socket.
What to do if Fellowes Calibre A3 pouch is lost in the machine?
If your Fellowes Laminator pouch is jammed, the machine will automatically reverse the document. If the jam isn't completely cleared, press and hold the reverse button while gently pulling on the pouch to remove it completely.
Why is the reverse button flashing red on my Fellowes Calibre A3 Laminator?
The reverse button is flashing red on your Fellowes Laminator because the machine has detected a mis-feed. The auto-reverse function has been activated.
Why does my Fellowes Laminator pouch have waves or bubbles?
If your Fellowes Laminator pouch has waves or bubbles, the temperature setting may be incorrect. Check that the pouch thickness is correctly selected and try passing it through the laminator again.
What to do if all LEDs are dimly blinking on Fellowes Calibre A3 Laminator?
If all the LEDs on your Fellowes Laminator are dimly blinking, the laminator has entered Auto Shut Off mode. To restart the machine, press any button or cycle the power switch.
Step-by-step guide for initial operation of the laminator.
Technical specifications and performance features of the laminator.
Critical safety guidelines to prevent injury and damage.
Highlights of special functions and helpful advice for optimal use.
Instructions for ensuring the machine is correctly positioned and ready for use.
Step-by-step process for operating the laminator for lamination.
Common problems, their possible causes, and recommended solutions.
Guidance on proper storage and maintenance procedures for the laminator.
General| Type | Cold laminator |
|---|---|
| Format | A3 |
| Control type | Buttons |
| Product color | Black |
| Auto power off | Yes |
| Preheating time | 1 min |
| Built-in display | No |
| Housing material | Plastic |
| Lamination speed | 500 mm/min |
| Lamination system | Pouch |
| Number of rollers | 2 |
| Auto power off after | 30 min |
| Maximum pouch thickness | 125 µm |
| Minimum pouch thickness | 75 µm |
| Maximum lamination width | 320 mm |
| Maximum document thickness | 125 mm |
| Harmonized System (HS) code | 84729080 |
| Quantity per master (outer) case | 2 pc(s) |
| Number of laminator pouches | 10 |
| Current | 3.4 A |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 - 60 Hz |
Weight and Dimensions| Depth | 155.6 mm |
|---|---|
| Width | 569.9 mm |
| Height | 109.5 mm |
| Weight | 2500 g |
| Package depth | 161.9 mm |
| Package width | 669.9 mm |
| Package height | 179.4 mm |
| Package weight | 3400 g |
To Next Page