Why is the 'ready' lamp not turning on after a long time on my Fellowes Laminator?
If the green 'ready' lamp on your Fellowes Laminator doesn't light up after a while, the machine may be in a hot or humid area. Move it to a cooler, drier location.
How to fix Fellowes Laminator when the power on lamp is not working?
If the red 'power on' lamp isn't lit on your Fellowes Laminator, the machine might not be switched on. Check that the machine is switched on both at the front and at the wall socket.
What to do if the Fellowes Laminator pouch is lost in the machine?
If a pouch gets stuck inside your Fellowes Laminator, it likely means the pouch is jammed. To resolve this, use the release lever and gently pull the item out by hand.
How to fix a Fellowes Callisto A3 that doesn't completely seal the item?
If your Fellowes Laminator pouch isn't sealing completely, it could be due to a few reasons. First, the item you're trying to laminate might be too thick; ensure the pass-through thickness is correctly selected, and try again. Alternatively, the temperature setting may be incorrect. Make sure the pouch thickness is correctly selected before running it through again.
What to do if the Fellowes Callisto A3 pouch has waves or bubbles?
If your Fellowes Laminator pouch comes out with waves or bubbles, the temperature setting might be incorrect. Verify that the pouch thickness is correctly selected and pass it through the laminator again.
How to fix Fellowes Laminator if pouch is lost in the machine?
If a pouch gets stuck inside your Fellowes Laminator, it means the pouch is jammed. Press the reverse button and gently pull the item out by hand.
What to do if Fellowes Callisto A3 pouch does not completely seal the item?
If your Fellowes Laminator pouch isn't sealing the item completely, it might be too thick to laminate. Check that the pass-through thickness is correctly selected, and then pass it through the laminator again.
What to do if Fellowes Callisto A3 Laminator pouch is damaged after lamination?
If the Fellowes Laminator pouch is damaged after lamination, the rollers may be damaged, or there may be adhesive on them. To test and clean the rollers, pass cleaning sheets through the machine.
Why does my Fellowes Laminator pouch have waves or bubbles?
If your laminated pouch has waves or bubbles, it might be due to an incorrect temperature setting. Check that the pouch thickness is correctly selected and try running it through the Fellowes Laminator again.
Why is the stand-by icon flashing on my Fellowes Callisto A3 Laminator?
If the stand-by icon is flashing on your Fellowes Laminator, it indicates the machine is in ‘Power Save’ mode. Press the ‘Stand-by’ button, and then select your preferred setting.
Identifies and describes the various controls on the laminator unit.
Provides visual, step-by-step instructions for initial setup and operation.
Details performance specifications, technical data, and wattage for the laminator.
Lists essential safety precautions to follow before, during, and after using the laminator.
Explains key functions and provides advice for optimal laminating results.
Ensures the machine is on a stable surface and properly plugged in.
Step-by-step guide on inserting documents, handling pouches, and cooling.
Addresses issues like no illumination, poor sealing, waves, bubbles, and jamming.
Details compliance with RoHS, Low Voltage, and EMC Directives and harmonised standards.
Provides contact phone numbers for Fellowes customer service across various countries.
General| Type | Hot Laminator |
|---|---|
| Warm-Up Time | 5 minutes |
| Number of Rollers | 2 |
| Max Laminating Width | A3 |
| Laminating Speed | 300 mm/min |
| Pouch Thickness | 75-125 microns |
To Next Page