To Next Page
O
odonnelljoshuaJul 26, 2025
What to do if my Fellowes Cosmic2 A3 pouch is lost in the machine?
- KKara BlackJul 26, 2025
If the pouch is jammed inside the Fellowes Laminator, operate the release lever and gently pull the item out by hand.
What to do if my Fellowes Cosmic2 A3 pouch is lost in the machine?
If the pouch is jammed inside the Fellowes Laminator, operate the release lever and gently pull the item out by hand.
How to fix no control panel illumination on Fellowes Laminator?
If there is no control panel illumination, the Fellowes Laminator might not be switched on. Turn on the machine at the rear next to the plug inlet and at the wall socket.
Why does my Fellowes Cosmic2 A3 pouch have waves or bubbles?
If the laminated pouch has waves or bubbles, the temperature setting may be incorrect. Check that the pouch thickness is correctly selected and pass it through the Fellowes Laminator again.
Why is my Fellowes Laminator pouch damaged after lamination?
If the pouch is damaged after lamination, the rollers may be damaged or have adhesive on them. Pass cleaning sheets through the Fellowes Laminator to test and clean the rollers.
What to do if my Fellowes Cosmic2 A3 Laminator pouch does not completely seal the item?
If the pouch does not completely seal the item, it might be because the item is too thick, or the temperature setting is incorrect. Check that the pass through thickness and pouch thickness are correctly selected, then pass the item through the Fellowes Laminator again.
On/off switch, standby button, pouch selection, and release lever for controlling the laminator's functions.
Key slots for inserting documents for lamination and retrieving the finished product.
Key features including the default cold setting and the pouch release lever for user convenience.
General| Maximum Laminating Width | A3 |
|---|---|
| Warm-up Time | 5 minutes |
| Laminating Speed | 30 cm/minute |
| Number of Rollers | 2 |
| Release Lever | Yes |
| Auto Shut-Off | No |
| Pouch Thickness | 75-125 microns |
