Why is my Fellowes Pixel A3 Laminator jamming?
Your Fellowes Laminator might be jamming because a pouch was used ‘open end’ first, the pouch was not centered on entry, the pouch was not straight upon entry, or an empty pouch was used.
How to fix Fellowes Pixel A3 pouch with waves or bubbles?
If your Fellowes Laminator pouch has waves or bubbles, the temperature setting may be incorrect. Check that the pouch thickness is correctly selected and pass it through the laminator again.
What to do if my Fellowes Pixel A3 Laminator pouch is lost in the machine?
If the pouch is jammed inside the Fellowes Laminator, operate the release lever and gently pull the item out by hand.
What to do if Fellowes Pixel A3 Laminator pouch does not completely seal?
If the Fellowes Laminator pouch does not completely seal the item, it could be because the item is too thick to laminate or the temperature setting is incorrect. Check that the pass through thickness and pouch thickness are correctly selected, then pass it through again.
Why does my Fellowes Laminator have no control panel illumination?
If your Fellowes Laminator has no control panel illumination, it could be because the machine is not switched on. Switch on the machine at the rear next to the plug inlet and at the wall socket. Alternatively, the laminator may have gone into Auto Shut Off mode; press any button or cycle the power switch to restart the machine.
Identifies the power switch, selection buttons, entry slot, exit, and release lever.
Details performance, technical data, format, entry width, and thickness limits.
Essential guidelines for safe operation and handling of the laminator.
Explains the automatic shut-off feature and the pouch release mechanism.
Provides advice for optimal lamination outcomes and pouch selection.
General| Type | Cold/hot laminator |
|---|---|
| Format | A3 |
| Warm-up time | 3 min |
| Product color | White |
| Auto power off | Yes |
| Preheating time | - min |
| Built-in display | No |
| Housing material | Plastic |
| Lamination speed | - mm/min |
| Lamination system | Pouch |
| Number of rollers | 2 |
| Auto power off after | 30 min |
| Maximum pouch thickness | 125 µm |
| Minimum pouch thickness | 80 µm |
| Maximum lamination width | 330 mm |
| Maximum document thickness | - mm |
| Number of laminator pouches | 10 |
Weight and Dimensions| Depth | 109.5 mm |
|---|---|
| Width | 435 mm |
| Height | 74.9 mm |
| Weight | 1680 g |
To Next Page