Page 7
TriumphLX Assembly
Step #11: turn the table upright
With the assistance of a helper, turn the table upright and place it in its final position.
IMPORTANT: There must be 1.0" (25mm) of clearance on all sides of the worksurface (and other moving parts) to ensure free, unobstructed movement.
• If necessary, adjust the leveling glides on the feet to level the worksurface.
• Plug the power cord into an AC outlet.
• Re-initialize the system. See Step 8 on page 6. IMPORTANT: Be sure there are no obstacles under the table that would prevent it from reaching its lowest position.
• See the following pages for operating procedures.
NOTE: Whenever the unit is unplugged or the power is cut, the table must be re-initialized.
To Next Page
Loading...
