Fellowes Jupiter 125 - Capabilities and Safety; General Safety Warnings

http://www.monomachines.com
ENGLISH
Opening lid to clean
laminating mechanism
Discrete carry
handles at I
Active Cooling System
Temperature controlled
release trigger for lid
CAPABILITIES
Pouch Thickness
3-7 mil
Estimated Heat-Up Time
4 Minutes
Approximate Cool-Down Time
60 Minutes
Lamination Speed
18"/Minute
Maximum Width
12.5" mm
Voltage
120V
Frequency
60 Hz
HeatGuard TechnologyTM double-walled
insulation keeps heat inside
LED Interface for
user guidance
Laminating capacity - 3-7 mil hot laminating pouches
Up to 12.5"
1000 Watt
Dimensions: 21 7/8" x9 Sja" x4 3f4"
Max document thickness 1/32"
IMPORTANT SAFETY INSTRUCTIONS - Please Read Before Using!
I AWARNINGI
• The socket-outlet must be installed near the equipment
and be easily accessible.
• To prevent electrical shock, do NOT use laminator close to water ("i;\
and do NOT spill water on laminator, electric cord, or wall socket. ~
• Do not leave electric cord in contact with a warm surface.
• Do not leave electric cord hanging from a cupboard or shelf.
• Do not use laminator if electric cord is damaged.
• Do not laminate metal objects.
IMPORTANT SAFETY INFORMATION
This laminator is equipped with an Auto shut-off function. It will turn the laminator into
stand-by mode, if it has not been used for over 60 minutes. To switch the laminator
back on, simply press the stand-by button at the left of the front operating panel.
I ACAUTIONI
• Only use pouches specifically designed for the lamination setting you intend to use.
• Always supervise children during laminator operation.
• Keep pets away from laminator while in use.
• Switch off and unplug laminator when not in use.
• Only open the laminator as explained under "Maintenance". Do not open or
attempt to repair in any other way, as this could result in electric shock and will
void your warranty. Contact Customer Service if you have questions. Please note
the warranty does not apply in cases of abuse, mishandling or unauthorized repair.
• Please be careful of sharp edges and corners and residual heat when opening
the laminator.
During lamination, the direction of the pouch can be reversed, if you are unsure about
the progress of the lamination. To do so, press down the reverse key. This will eject
the pauch back at the front entry.
http://www.monomachines.com
2