Fellowes Jupiter 125 - Lamination Procedures; Cold Lamination Steps

http://www.monomachines.com
TIPS
• Always put item in a pouch. Never laminate an empty pouch.
• Trim excess pouch material from around your item after laminating
and cooling.
• Clean laminator rollers with Fellowes roller wipes (item #5703702) after
15-20 laminations to guarantee optimum laminating results. For further
details, please see "maintenance" section.
BEFORE YOU LAMINATE
Use Fellowes® brand pouches
for best results. Select correct
pouch size for laminated item.
COLD LAMINATION STEPS
CAUTION: Only use self-adhesive pouches when laminating with a cold setting.
1. Please connect the laminator to
the socket using the separate power
cable supplied.
2. Switch laminator on with
Power On / Off button at back
of machine.
5. Confirm your selection by
pressing "Enter" button in the middle
of navigation keys. "Wait" LED
(~) will stop flashing and beep will
sound when laminator has finished
temperature adjustment.
6
6. Center item on clear side against
sealed edge; documents cannot be
repositioned once laminated.
• Before laminating valuable items, do a test run with an item similar
in size and thickness.
• Do not laminate heat-sensitive documents (Le., tickets, ultrasounds, etc.).
• Use a dry-erase marker for writing on laminated pouches.
Position laminator
so you have enough
space to allow
items to pass freely
through the machine.
3. Press Stand-by button at left
of front operating panel to switch
laminator on.
4. Use navigation keys to select
setting for cold lamination.
7. Peel a small part of the protective
sheet away from document.
8. When the "wait" LED (~) stops
flashing, place pouch, sealed edge
first, into laminator entry. Keep
pouch straight and use the edge
guide to center it. Continue peeling
the protective sheet away.
http://www.monomachines.com
3