Fellowes Jupiter 125 - Hot Lamination Steps

http://www.monomachines.com
ENGLISH
HOT LAMINATION STEPS
1. Please connect the laminator to the
socket using the separate power cable
supplied.
2. Switch laminator on with Power On /
Off button at back of machine.
4. Use navigation keys to select setting for
the hot lamination pouch thickness (3-7
mil) you wish to laminate.
7. "Wait" LED (~) will stop flashing
and acoustic bleep signal will sound when
machine is ready to laminate selected pouch
thickness.
10
5. Confirm your selection by pressing "Enter"
button in the middle of navigation keys.
"Wait" LED (0 will begin flashing and
laminator will take a few minutes to reach
required temperature.
8. Place pouch, sealed edge first, into
laminator entry. Keep pouch straight and
use the edge guide to center it.
3. Press Stand-by button at left of front
operating panel to switch laminator on.
6
6. While laminator is warming up, please
prepare item you wish to laminate. Place the
item inside the pouch and center it against the
sealed edge of the pouch. To prevent jamming,
use a carrier sheet when item is smaller than
the pouch.
9
9. To prevent jamming, immediately remove
laminated item from beck of machine. Let
item coolon flat surface for several seconds.
10. Before switching off laminator, feed
empty cleaning sheet through machine to
clean unit.
http://www.monomachines.com
4
I
I