Reverb Footswitch/LED
Activates reverb effect; LED illuminates.
Output Jack
Low-impedance output jack connects to amp or to next effect pedal in
signal chain.
Tilt
Adjusts tonal balance from more bass heavy to more treble heavy.
Response is flat when control is centered, and there are more high
frequencies and less low frequencies as the control is rotated clockwise,
and vice-versa.
Type Switch
Selects active reverb algorithm, or sound.
Level
Controls overall output level.
Damping
Controls how fast high frequencies decay in the reverb sound.
Increasing this control will make the reverb tail darker as it fades out.
Time
Controls reverb decay time.
Gain Control/LED
Sets overall pedal sensitivity and allows for a broadrange of instruments
to be used. Peak LED will flicker when unit is close to distorting.
Polarity Switch
Inverts signal polarity (or “phase”), and is sometimes useful in reducing
or eliminating unwanted feedback.
To Next Page