FENDT IDEAL Series User Manual

1.4 Safety instructions
1.4.1 Engine safety instructions
• Make sure that all shields, guards and access doors are in the correct position and closed before you
start the engine.
• Make sure that no personnel are near the machine before you start the engine. Operate the horn 2
times before you start the engine to warn personnel.
• Before you start the engine, make sure that:
- All the controls are in the neutral position.
- The drive systems are in the disengaged position.
• If you start the engine in a closed area, make sure that there is sucient airflow.
• Start the engine from the operator seat only.
• Start the engine only with the start switch in the cab.
• If the machine is in gear, the neutral start system makes sure that the engine does not start. If you
override this system, it can cause death or injury.
• Do not connect booster cables to the starter motor terminals.
• Do not use starter fluid to start the engine. This can cause:
- Explosions
- Injury to personnel
- Damage to the machine.
• Keep away from the engine while it is in operation. Before you open the engine cover, stop the engine
and remove the ignition key.
• Do not smoke, have an open fire, or a source of ignition near the fuel system or batteries.
• Do not touch the exhaust manifold, turbocharger and the other hot parts of the engine.
• Do not operate the engine at the idle speed when it is not necessary.
• Keep the engine surfaces clean to prevent the risk of fire.
• Do not disconnect fuel pipes and hoses when the engine is ON. Stop the engine and wait 30 seconds
before you disconnect fuel pipes and hoses.
• The engine contains seals made of viton. If viton is exposed to heat above 300 °C hydrofluoric acid is
made. Put on gloves and clean the area with a alkaline fluid to prevent injury.
• Before you do welding on the machine you must disconnect the:
- Battery
- Engine electronic control unit
- Selective Catalyst Reduction (SCR) supply module.
Cleaning instructions
• To prevent damage to the machine, do not
clean these components with high pressure
fluid:
- Electrical equipment
- Fuel system
- Radiator.
• When you clean the engine, remove unwanted
areas of moisture and then operate the engine
to dry the remaining moisture.
GUID-2769EE7D-AD9B-40B1-869E-CC010E4E300E-high.jpg [High]
Fig. 2
[V]
GUID-537F9C82-FFA9-45E5-92E4-D84B547112BD [V1]
1. Safety
IDEAL Series Combine 25
ACX2738370
Find manuals at https://best-manuals.com

FENDT IDEAL Series Specifications

General

Brand	FENDT
Model	IDEAL Series
Category	Farm Equipment
Language	English