6 Ferm
SPARE PARTS LIST FFZ-400N
REF NR DESCRIPTION FERM NR
015 - 020 BOLSTER THREADED COMPLETE 209860
023 PRESSING PLATE 209861
024 SPRING 209862
025 BUSHING 209863
026 UPPER ARM 209864
028 SAW BLADE HOLDER (UPPER) 209865
033 + 034 CONNECTION PLATE + BEARING 209866
039 LOWER ARM 209867
041 SAW BLADE HOLDER (LOWER) 209868
042 - 044 AIR HOSE + PLASTIC PLATE 209869
047 TRANSPARENT GUARD 209870
049 GAS BAG 209871
052 CAM 209872
055 TABLE INSERT 209873
056 MOTOR 209874
065 SUPPORT FRAME 209875
069 - 072 MITRE GUIDE COMPLETE 209876
SWITCH 209877
OPERATIONAL SAFETY
Warning!
This machine can produce fine dust, which is harm-
ful to your health. Always wear a suitable dust mask and other
protection equipment as appropriate.
Concentrate
Routine and repetition can lead to mistakes. Remember
that a slight lack of concentration can result in serious
injuries in a split second.
Keep work area clean
Cluttered areas and benches invite injuries.
Consider the work environment
Do not expose power tools to rain or use them in damp
or wet locations. Keep work area well lit. Do not use
power tools in the presence of flammable liquids, vap-
ours or gases.
Guard against electric shock
This unit contains dangerous voltages. Use a RCD (resi-
dual current device) to provide protection against elec-
trical shock. Prevent body contact with grounded sur-
faces (e.g. pipes, radiator, ranges or refrigerators).
Keep children and pets away
Do not let children or pets come into contact with the
tool, extension cable or work area.
Do not force the tool
It will work better and safer at the rate for which it was
intended.
Use the right tool
Do not force small tools or attachments to do the job of a
heavy-duty tool. Do not use tools for purposes for which
they were not intended; for example do not use a circular
saw for cutting trees or logs.
Do not abuse cable
Never carry the tool by the cable or pull it to disconnect
it from the power socket. Keep the cable away from heat,
oil and sharp edges. Do not touch the metal plug pins
when connecting or removing the plug.
Do not over-reach
Keep a proper footing and balance at all times.
Disconnect tools from power supply
When not in use, before servicing and when changing
accessories such as blades, bits and cutters.
Always switch off and unplug the saw from the
power supply before making adjustments or chan-
ging blades.
Remove adjusting keys and wrenches
Ensure that they are removed from the tool before swit-
ching on.
Avoid unintentional starting
Do not carry plugged in tools with your finger on the
switch. Check that the switch is off before plugging in to
socket.
Connect a dust extraction device
Whenever there are facilities for fitting a dust of fume
extraction system, make sure it is connected and used.
Use recommended accessories
The use of any other accessory or attachment other than
recommended in the instructions or catalogue may pre-
sent a risk of personal injury. Use extension cables suita-
ble for the power input of the saw (minimum cable size
1.5mm
2
). When using a cable reel unwind the cable fully.
Ferm 3
To Next Page
Loading...
