16
Configuration for SIP server integration
Configure the SIP parameters as explained below, for the cases where the KIN panel works as an
extension of a SIP server.
Contact with the SIP server administrator to get some of the information required in this section.
ENABLE SIP: Select this box to enable SIP functions.
SIP SERVER: Indicate the sip SERVER address. Format -> sip: IP_SERVER
DOMAIN: domain of the SIP server or IP address
OUTBOUND: Not necessary. Leave it in blank.
STUN IP: domain of the SIP server
STUN PORT: Used for the configuration of Internet SIP server-based installations. It is usually
port 5060. Check with your network or SIP server administrator.
H.264: Depends on the SIP SERVER. In the case of doubt, leave the default value.
SIP USER, SIP PASSWORD: Indicate the user and password that this terminal is programmed
in the SIP server.
CONVERSATION, RING TIME: No function.
To Next Page
Loading...
