FERNO/MAN/01/18/159/UK 4 Pegasus Trolley
3. Operating Procedure
WARNING
Always ensure that two operators are with a laden trolley at all times.
Ensure that the following procedures are complied with:
1. Advise the patient before making adjustments, lifting or loading the trolley.
2. Stay with the patient and control the trolley at all times.
3. Keep the patient restrained and the cot side rails up when using the trolley.
4. Use help when needed to ensure patient and operator safety.
Transferring a Patient onto a Trolley
1. Lower the cot side rails.
2. Place the trolley beside the patient and open the restraints.
3. Ensure that at least one wheel brake at each end of the trolley is applied.
4. Transfer the patient onto the trolley using recognised manual handling
procedures.
5. Close the restraints around the patient (see page 11).
6. Raise the cot side rails and lock in position.
7. Make adjustments as necessary.
When transferring a patient from a bed or other apparatus,
1. Raise/lower the trolley to a suitable height.
2. Proceed with the transfer as aforementioned.
Height Adjustment – Do not raise the trolley when located in the vehicle lock.
1. The height adjustment of the Pegasus is achieved by a simple hydraulic pumping
action.
2. The raising and lowering action is achieved by means of foot pedals, which are
located on each side of the trolley. NOTE ensure pedals on both sides are clear
before operating.
To Next Page
Loading...
