Ferno POWERFlexx - Safety and Instruction Labels

6 © Ferno-Washington, Inc. 234-3310-01 May 2005
POWERFlexx
™
1.5 Safety and Instruction Labels
Safety and instruction labels place important information from the users’ manual on the cot. Read and follow
label instructions. Replace worn or damaged labels immediately. See Parts and Service, page 38.
Safety Information
Label A (1 per cot) - Summary of instructions for safe
and proper operation of the cot.
Label D (1 per cot) - Indicates the
location of the control used to operate
the cot manually.
Label B and Label C
(6 total per cot) -
Indicates that fingers or
hands can be injured if
placed near areas of the
cot where these labels
are located.
Label E and Label F
(4 total per cot) -
Indicates that fingers or
hands can be injured if
placed near areas of the
cot where these labels
are located.
LABELS AFFIXED TO THE COT
LABELS AFFIXED TO THE POWER PACK
Label D (1) - Indicates Power Pack
contents and specifies service personnel.
Label B (1) - Indicates where to connect
the actuator cable to the power pack.
Label C (1) - Indicates where to connect
the charging cable to the power pack.
Label A (1) - Indicates where to connect
the control-unit cable to the power pack.