Bedienung
31
Safety information
• Make sure that the tree is always between you and the saw.
• Remove larger, supporting branches using the method from Section „Log division
without support“.
• Always remove small freely suspended parts of the tree with a top cut. They may fall
into the saw or trap it if you use an undercut.
Pruning (Fig. K)
m CAUTION
Prune branches only at or below shoulder height. Never cut branches above shoulder
height. Leave that kind of work to a professional.
• For the first cut (Pos. 1), cut 1/3 of the way into the lower part of the branch.
• Then cut all the way through the branch with the second cut (Pos. 2). The third cut
(Pos. 3) is a top cut with which you separate the branch from the trunk at a distance
of 2.5 to 5cm.
6.8 Remaining risks
m DANGER
MECHANICAL HAZARDS
Rotating chain
Moving Training Elements
Parts expelled by moving chain
Break in the chain
Disturbance of the engine control system or control elements that would cause the chain
to start unexpectedly while the chain saw is running, an unexpected increase in engine
speed.
ELECTRICAL HAZARDS
from contact with parts under high voltage (direct contact) or parts which have become
under high voltage under faulty conditions (indirect contact).
THERMAL HAZARDS
which can result in burns, scalds and other injuries, created by possible contact of per-
sons with objects or materials with high temperature including the radiation of heat
sources.
To Next Page
Loading...
