Bedienung
41
Maintenance, Servicing
m NOTE
To stop the engine in an emergency, activate the chain brake and set the ON / OFF switch
to „Stop“.
10. Cleaning
m WARNING
Disconnect the spark plug boot before doing any cleaning and maintenance work. (Fig.
19)
Cleaning
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure. ATTENTION! Wear safety glasses!
• We recommend that you clean the device immediately each time you have finished
using it.
• Clean the equipment regularly with a moist cloth and some soft soap. Do not use clean-
ing agents or solvents; these could attack the plastic parts of the equipment. Ensure
that no water can seep into the device.
11. Maintenance, Servicing
Air filter (Fig.16-18)
• Clean the air filter (H) after each use.
• Unscrew the air filter mounting nut (Fig.18/Pos.6) and remove the cover. (see Fig.16)
• Remove the air filter (H).
• Open the air filter with a screwdriver.
• Clean the air filter. Wash the filter in clean, warm, soapy water. Let the air dry com-
pletely.
• Insert the air filter. Put on the cover of the engine / air filter. Make sure the cover is in-
stalled correctly (S-V). Tighten the screw that secures the cover. (see Fig.16)
m NOTE
It is advisable to keep a stock of spare filters.
Oil supply opening (Fig.20)
• Check the oil outlet (K) after each use.
• Dissemble the bar.
• Check the oil outlet (K) for obstructions.
To Next Page
Loading...
