Bedienung
47
Every 3
months
Fuel filter
Fuel, oil tank
Replace
Clean
Storage Chain saw
Guide bar/ chain
Fuel, oil tank
Carburretor
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Demount, clean and oil slightly
Clean the guide groove of the guide bar
Empty and clean
Run empty
Service information
Please note that the following parts of this product are subject to normal or natural wear
and that the following parts are therefore also required for use as consumables.
Wear parts*: Saw chain, Guide bar, Saw chain oil, Engine oil, Spiked bumper, Chain catch-
er, Spark plug, air filter, fuel filter, saw chain oil filter
* Not necessarily included in the scope of delivery!
12. Storage
m CAUTION!
Never put a chain saw into storage for longer than 30 days without carrying out the fol-
lowing steps.
Follow the cleaning instructions and maintenance instructions before storing the device.
Storing a chain saw
Storing a chain saw for longer than 30 days requires storage maintenance. Unless the
storage instructions are followed, fuel remaining in the carburetor will evaporate, leav-
ing gum-like deposits. This could lead to difficult starting and result in costly repairs.
• Remove the fuel tank cap slowly to release any pressure in tank. Carefully drain the
fuel tank.
• Start the engine and let it run until the unit stops to remove fuel from carburetor.
• Allow the engine to cool (approx. 5 minutes).
• Remove the spark plug.
• Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope
slowly several times to coat internal components. Replace spark plug.
m NOTE
Store the unit in a dry place and away from possible sources of ignition such as a furnace,
gas hot water heater, gas dryer, etc.
Maintenance, Servicing/Storage
To Next Page
Loading...
