46
Symbole
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the fol-
lowing maintenance must be performed regularly. Guarantee claims can be recognized only if
this work is performed regularly and properly. Failure to perform the prescribed maintenance
work can lead to accidents!
The user of the chain saw must not perform maintenance work which is not described in the in-
struction manual.
All other work may only be performed by a specialist workshop.
General Chain saw
Saw chain
Chain brake
Guide bar
Clean exterior, check for damage. In case of damage
have repaired by a qualified service center immediately
Sharpen regulary, replace in good time
Have inspected regularly at an authorized service center
Turn over to ensure even wear of bearing surfaces
Replace in good time
Before each
start
Saw chain
Guide bar
Chain lubrication
Chain brake
OFF switch, Safety
locking button,
Throttle lever
Fuel/ oil tank cup
Inspect for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Functional check
Check for tightness and leckage
Every day Air filter
Guide bar
Guide bar support
Idle speed
Clean
Check for damage, clean oil intake bore
Clean, in particular the oil guide groove
Check (chain must not run)
Every week Fan housing
Cylinder space
Spark plug
Muffler
Spark arrester screen
Chain catch sleeve
Screws and nuts
Clean to ensure proper air cooling
Clean
Check and replace if necessary
Check tightness of mounting
Clean
Check for damage, replace if necessary.
Check their condition and that they are firmly secured.
Maintenance, Servicing
To Next Page
Loading...
