Bedienung
43
Spark plug (Fig.17-19,22)
m NOTE!: In order for the saw motor to remain powerful, the spark plug (G) must be clean
and properly gapped (0.6-0.7 mm). Spark plugs should be cleaned or replaced every 20
hours.
• Set the ON/OFF switch (11) to „Stop“.
• Remove the air filter cover (5) by removing the air filter mounting nut (6). The cover
can then be removed.
• Disconnect the spark plug from the ignition wire by gently pulling it and turning the
spark plug (G).
• Remove the spark plug with a spark plug wrench (20). Do not use other tools.
• Clean the spark plug with a copper wire brush or replace it with a new one. (Fig.22)
Adjusting the idling speed (Fig. 25)
If the saw chain continues to idle, you must correct the idle speed.
1. Remove the plug (T).
2. Let the engine warm up for 3-5 minutes (no high speeds!).
3. Turn the adjusting screw (R) using a flat-head screwdriver:
clockwise
- Idle speed increases (+)
counterclockwise
- Idle speed decreases (-)
Idling speed max.: 3500 min
-1
Contact the manufacturer if the saw chain continues to idle.
Attention! Do not work on the chain saw!
Important: No adjustments can be made to the plug L / H.
Carburetor setting
The carburetor has been set to its perfect adjustment at the factory. If it requires adjust-
ing, take the saw to your nearest authorized after-sales service outlet.
m WARNING!: You may not make settings on the carburetor itself!
Bar
• Check after every 8 hours of work to ensure uniform wear.
Saw chain
Saw chain Tension
Periodically check the chain tension and adjust if necessary, so that after use the chain is
snug against the rail, but still loose enough that it can be pulled by hand. (Fig.8)
Maintenance, Servicing
To Next Page
Loading...
