A13+A1+A14+ A2, EN 50636-2-100:2014) and can be used to compare one power tool
with another. They can also be used for a preliminary assessment of exposure.
Warning!
The vibration and noise emissions can deviate from the stated values during actual
use of the power tool. This depends on the way the power tool is actually used and
especially on the type of workpiece you are working on.
It is necessary to establish safety measures that protect the operator based on an
estimate of the exposure during actual conditions of use (taking into account all
parts of the operating cycle, such as periods when the power tool is switched off and
periods when it is switched on but running without load).
Try to keep the exposure to vibrations and noise as low as possible. Examples of
measures to reduce the exposure:
- wearing vibration-damping gloves while using the tool;
- limiting the working time;
- using accessories in good condition;
- regular maintenance and cleaning of the device;
- turning the device off while not in use;
- preventing overload of the device.
Technical data
28
To Next Page
Loading...
