Ferris HydroCut Series User Manual

19
Regular Maintenance
MAINTENANCE SCHEDULE & PROCEDURES
The following schedule should be followed for normal care of your rider and mower. You will need to keep a
record of your operating time. Determining operating time is easily accomplished by multiplying the time it takes
to do one job by the number of times you’ve done the job, or you can install an hour meter.
* Refer to engine owner’s manual. Change original engine oil after initial break-in period.
** More often in hot (over 85° F: 30° C) weather or dusty operating conditions.
*** Service after the first 25 hours, then after every 100 hours of operation.
**** If equipped. Replace if damaged
SAFETY ITEMS
Before
Each
Use
Every
5
Hours
Every
25
Hours
Every
50
Hours
Every
100
Hours
Every
250
Hours
Spring
and
Fall
Check Safety Interlock System
••
Check Mower Blade Stopping Time
••
TRACTOR CARE ITEMS
Before
Each
Use
Every
5
Hours
Every
25
Hours
Every
50
Hours
Every
100
Hours
Every
250
Hours
Spring
and
Fall
Check Mower for loose hardware
••
Check / Adjust PTO Clutch
*** •
Lubricate Mower **
•
Clean Battery & Cables
•
Check Tire Pressure
••
Clean Deck & Check/Replace Mower
Blades
•
ENGINE CARE ITEMS
Before
Each
Use
Every
5
Hours
Every
25
Hours
Every
50
Hours
Every
100
Hours
Every
250
Hours
Spring
and
Fall
Check Engine Oil Level
•
Check / Clean Engine Cooling Fins
•**
Check / Change Engine Air Filter *
•**
Change Engine Oil & Filter *
•
Inspect Spark Plug(s) *
•
Check / Replace Fuel Filter *
•
Inspect / Clean Spark Arrester****
•
Not for
Reproduction

Ferris HydroCut Series Specifications

General

Brand	Ferris
Model	HydroCut Series
Category	Lawn Mower
Language	English